Stone Edge Surfaces SwiftSet Self-Leveler is a fast setting (2-4 hours) and walkable in (4- 6 hours), pre-sanded, single component just add water, polymer enhanced, Portland cement and proprietary additive self-leveling underlayment or base coat mix used to create a smooth flat and level surfaces for the installation of various flooring types.
SwiftSet Self Leveler is used to repair or level low spots in concrete substrates.
SwiftSet Self-Leveler creates a strong physical & chemical bond to a concrete substrate with the use of Stone Edge Surfaces Primer 100, and you can achieve a deeper fill by adding aggregate.
The following Averages vary by thickness, temp, etc.:
Set Time, 2-4 hours
Walkable in 4-6 hours.
Floor Coverings in 4–8 hours (non-moisture sensitive).
Floor Covering 16-24 hours (moisture sensitive).
Polishing 3 to 7 days. NOTE: SwiftSet is mainly used as an underlayment, and if used as a top coat layer keep in mind that color may not be consistant throughout. Again, SwiftSet is mainly an underlayment.
Driveable in 24-48 hours.
SwiftSet Self-Leveler is for indoor or outdoor use, is ASTM E84 fire rated and dries to over 7,000 psi.
MOST COMMON USES
Smooth, Flat Level surface for the installation of tile, carpet and other flooring types.
Sound and Fire and Smoke mitigation when combined with other sound mitigating materials
BASE/TOP COAT: Underlayment and Potentially a Top Coat if Polished THICKNESS: feathered to 1.5” … Can Go 2” and up to 3”+ With Aggregate APPLICATION METHOD: Mix – Pour or Pump WORKING TIME: 15-20 Minutes depending on Temperature and other conditions with set time of 2-4 hours and walkable within 4 to 6 hrs based on thickness. COLOR: Gray HARDNESS: 7,000 PSI+ USE WITH PRIMER…Yes, Required