Stone Edge Surfaces Polymeric Paver Sand is a non hazing and low dust polymeric paver and tile joint filler that has consistent sand color throughout.
Stone Edge Surfaces Polymeric Paver Sand is 100% polymeric sand with:
NO – Cement
NO – Liquid Epoxy
NO = Haze
NO – Acrylic Concentrate to float to the surface and carry sand grains over the pavers or tile which creates a film or “haze”.
Stone Edge Surfaces Polymeric Paver Sand is permeable and percolates to allow water to pass through.
Stone Edge Surfaces Polymeric Paver Sand is self-healing, flexible, locks in joints better, and is an ant and weed deterrent with superior bonding properties and longevity.
Stone Edge Surfaces
MOST COMMON USES
TAN Poly Sand is a fine joint sand blend and is mainly used for Travertine, Artistic Pavers, or any paver or tile that has fine joints and needs a smaller grain sand to fill tighter joints.
Sable Black Poly Sand has a heavier gradation of sand and is used for Pavers, Travertine and Artistic Pavers, Slate, and Natural Stone where there are wider joints to be filled.
APPLICATION METHOD: Pour Stone Edge Surfaces Polymeric Paver Sand onto dry pavers, travertine, stone, etc., and sweep into the joints. Tap on the pavers by hand or through mechanical means to get sand to settle more deeply into the joints.
Brush or sweep all sand off the pavers. Lightly spray water over the pavers and joints. Water, the just sanded paver area for about 10 seconds at a time. Allow 24 hours before foot traffic.
COMMONLY APPLIED IN THE JOINTS OF: • Brick pavers, Concrete pavers, Travertine pavers, Flagstone, Natural Stone, stone tiles, and more